User Tools

Site Tools


nnm:faq

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
nnm:faq [2022/01/18 16:01]
carola.burkl [I don't understand the $\bf{k} \cdot \bf{p}$ parameters]
nnm:faq [2022/01/18 16:38]
carola.burkl
Line 2: Line 2:
  
 New documentation for FAQ https://​www.nextnano.com/​manual/​faq/​index.html New documentation for FAQ https://​www.nextnano.com/​manual/​faq/​index.html
- 
- 
- 
- 
- 
- 
- 
- 
- 
-= 
- 
- 
- 
-==== How shall I cite the nextnano software in publications?​ ==== 
- 
-You can cite any of the following papers: 
-  * [[http://​dx.doi.org/​10.1109/​TED.2007.902871|nextnano:​ General Purpose 3-D Simulations]]\\ S. Birner, T. Zibold, T. Andlauer, T. Kubis, M. Sabathil, A. Trellakis, P. Vogl \\ IEEE Trans. Electron Dev. **54**, 2137 (2007) 
-  * [[http://​dx.doi.org/​10.1007/​s10825-006-0005-x|The 3D nanometer device project nextnano: Concepts, methods, results]]\\ A. Trellakis, T. Zibold, T. Andlauer, S. Birner, R. K. Smith, R. Morschl, P. Vogl\\ J. Comput. Electron. **5**, 285 (2006) 
- 
-For simulations including electrolytes,​ you should cite: 
-  * [[http://​stacks.iop.org/​1742-6596/​107/​i=1/​a=012002|Theoretical model for the detection of charged proteins with a silicon-on-insulator sensor]]\\ S. Birner, C. Uhl, M. Bayer, P. Vogl\\ J. Phys.: Conf. Ser. **107**, 012002 (2008) ​ 
- 
-For simulations that use the Contact Block Reduction method (CBR) (ballistic transport), you should cite any of the following papers: 
-  * [[http://​dx.doi.org/​10.1063/​1.1560567|Efficient method for the calculation of ballistic quantum transport]]\\ D. Mamaluy, M. Sabathil, P. Vogl\\ J. Appl. Phys. **93**, 4628 (2003) 
-  * [[http://​dx.doi.org/​10.1007/​s10825-009-0293-z|Ballistic quantum transport using the contact block reduction (CBR) method - An introduction]]\\ S. Birner, C. Schindler, P. Greck, M. Sabathil, P. Vogl\\ J. Comput. Electron. **8**, 267 (2009) 
- 
-nextnano.MSB software: For simulations that use the multi-scattering Büttiker (MSB) probe model (NEGF), you should cite: 
-  * [[https://​doi.org/​10.1364/​OE.23.006587|Efficient method for the calculation of dissipative quantum transport in quantum cascade lasers]]\\ P. Greck, S. Birner, B. Huber, P. Vogl\\ Optics Express **23**, 6587 
- 
-nextnano.QCLsoftware:​ For simulations that use the NEGF method, you should cite: 
-  * [[http://​dx.doi.org/​10.1103/​PhysRevB.92.241306|Contrasting influence of charged impurities on transport and gain in terahertz quantum cascade lasers]]\\ T. Grange\\ Phys. Rev. B **92**, 241306(R) (2015) 
- 
-For simulations that use the NEGF algorithm included in the nextnano³ software, you should cite any of these publications:​ 
-  * [[http://​dx.doi.org/​10.1063/​1.4863665|Modeling techniques for quantum cascade lasers 
-]]\\ C. Jirauschek, T. Kubis\\ Appl. Phys. Rev. **1**, 011307 (2014) 
-  * [[https://​doi.org/​10.1103/​PhysRevB.79.195323|Theory of non-equilibrium quantum transport and energy dissipation in terahertz quantum cascade lasers]]\\ T. Kubis, C. Yeh, P. Vogl, A. Benz, G. Fasching, C. Deutsch\\ Phys. Rev. B **79**, 195323 (2009) 
- 
-There might be further papers in the literature that are more suited to be cited in certain cases. 
- 
-----